1/4" Wire Rope Clip, Forged Steel, Stainless Steel.

Key Features

• Manufactured from stainless steel.
• Recommended for 1/4" guy wire (SRET635CAM or SRET14DA)
• Recommended usage per connection: 3 pieces
• Ideal for heavy-duty loads
• Recommended for suspension or securing guyed towers, masts, poles, and similar structures.

Safety Notes

Use the same size wire rope clip for the same size steel cable.

Never use malleable iron clips in critical, heavy-duty applications, or for suspended loads such as slings, suspension lines, guy lines, tow lines, load securing, scaffolding, etc.

Malleable iron clips are for making terminations:

• Only for light-duty and non-critical applications such as light loads, handrails, trellises, area guards, etc.
• Apply an initial load to test the assembly. This load must be equal to or greater than the weight it will support. Then, verify and re-tighten the nuts to the recommended torque.

Wire Rope Clip Installation Method

1. Loop the cable the necessary length around the thimble and install the first clip at a distance equal to the width of its base from the dead end of the cable. Tighten the nuts alternately to the specified torque.
2. When only two clips are necessary, install the second as close as possible to the cable bend or thimble, and tighten the nuts alternately to the specified torque. When more than two clips are required, install the second clip as close as possible to the cable bend or thimble and turn the nuts firmly without tightening them fully.
3. Install all necessary clips between the first two with equal spacing, and located in the same position. Ensure that the nuts on all clips are tightened according to the specified torque.
4. Finally, apply a load equal to or greater than the intended load to test the assembly. Immediately check, and if necessary, re-tighten the nuts according to the recommended torque using a torque wrench.