Key Features
- Made of forged steel
- Hot-dip galvanized coating
- Recommended maximum torque: 35 N.m
- Recommended for 1/4' guy wire (SRET635CAM or SRET14DA)
- Recommended use per tie-off: 3 pieces
- Ideal for heavy loads
- Recommended for suspension or securing guyed towers, masts, poles, and similar structures
Safety Notes
- Use the same size wire rope clip for the same size steel cable
- Never use malleable iron clips in critical or heavy-duty applications, or for overhead loads such as slings, suspension lines, guy lines, drag lines, load securing, scaffolding, etc.
- Malleable iron clips are for terminations only
- Only for light-duty and non-critical applications such as light loads, handrails, trellises, area fencing, etc.
- Apply an initial load to test the assembly. This load must be equal to or greater than the weight it will support. Then, check and re-tighten the nuts to the recommended torque.
Wire Rope Clip Installation Method
- Loop the cable the necessary length around the thimble, and install the first clip at a distance from the extreme end of the cable equal to the width of its base. Tighten the nuts alternately to the specified torque.
- When only two clips are needed, install the second one as close as possible to the loop of the cable or thimble, and tighten the nuts alternately to the specified torque. When more than two clips are required, install the second clip as close as possible to the loop of the cable or thimble and turn the nuts firmly without tightening them completely.
- Install all necessary clips between the first two with equal spacing between each other, and positioned in the same orientation. Ensure the nuts on all clips are tightened to the specified torque.
- Finally, apply a load equal to or greater than the expected load to test the assembly. Immediately check, and if necessary, re-tighten the nuts according to the recommended torque using a torque wrench.
