1
/
of
1
SYSCOM TOWERS
Wire Rope Clip/Clamp, Forged Steel for 1/8", Hot-Dip Galvanized.
Wire Rope Clip/Clamp, Forged Steel for 1/8", Hot-Dip Galvanized.
Regular price
$ 99.00
Regular price
Sale price
$ 99.00
Taxes included.
Shipping calculated at checkout.
Quantity
Couldn't load pickup availability
Vendido por Glaretum, Proveedor de Servicio Autorizado Apple
Paga con tarjeta, Apple Pay o PayPal
¿Dudas? Escríbenos por WhatsApp o llama al 800 461 0096
Key Features
- Made of forged steel
- Hot-dip galvanized coating
- Recommended maximum torque: 6 N.m
- Recommended for 1/8" guy wire (SRET318CAM or SRET18DA)
- Recommended usage per tie-off: 3 pieces
- Ideal for heavy loads
- Recommended for suspension or securing of guyed towers, masts, poles, and similar structures
Safety Notes
- Use the same size clip for the same wire rope size
- Never use malleable iron clips in critical, heavy-duty applications, or for suspension loads, such as slings, suspension lines, guide lines, tow lines, cargo securing, scaffolding, etc.
- Malleable iron clips are intended for terminations:
- Only for light-duty and non-critical applications such as light loads, handrails, fencing, area protection, etc.
- Apply an initial load to test the assembly. This load should be equal to or greater than the load it will support. Then, check and retighten the nuts to the recommended torque.
Installation Method for Wire Rope Clips
- Loop the wire rope around the thimble for the required length, and install the first clip at a distance equal to the width of its base from the end of the wire rope. Tighten the nuts alternately to the specified torque.
- When only two clips are necessary, install the second one as close as possible to the bend of the wire or the thimble, and tighten the nuts alternately to the specified torque. When more than two clips are required, install the second clip as close as possible to the bend of the wire or the thimble and turn the nuts firmly without tightening completely.
- Install all required clips between the first two with equal spacing between them, all in the same orientation. Ensure the nuts on all clips are tightened to the specified torque.
- Finally, apply a load equal to or greater than the anticipated usage load to test the assembly. Immediately check and, if necessary, retighten the nuts to the recommended torque using a torque wrench.


